Test Method for Determination of Hydraulic Conductivity of Porous Material Using a Rigid-wall Compaction-Mold Permeameter. Start. Standard ASTM standard · ASTM D Status: Withdrawn · Replaced by: ASTM D Soil and Rock (I): D – D (ASTM VOL ). ASTM D Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold.
|Published (Last):||12 July 2010|
|PDF File Size:||10.21 Mb|
|ePub File Size:||5.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
The test method is designed to minimize the r5856 of air in the test specimen. It is not possible to buy in the shop – please contact us. However, this test method does not ensure complete saturation of the test specimen with water. Are you sure you want to unsubscribe monitoring?
Username or d556 invalid. Please choose number of devices you want to open the document on. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. By tradition in U. Astk, the results should be applied to field situations with caution and by qualified personnel. Test Method D is recommended adtm any material that tends to shrink when exposed to the permeant liquid.
Activation of monitoring failed – please try again later or contact us. However, when the hydraulic gradient acting on a test specimen is changed, the state of stress will also change, and, if the ashm or pore fluid is compressible, the volume of the test specimen or pore fluid will change. Link to Active This link will always route to the current Active version of the standard. In cases where it is essential to saturate the test specimen fully with water, the compacted specimen may be tested using Test Method D Activation of your subscription failed – please try again later or contact us.
ASTM D5856 – 15
Du abonnerer allerede dette emne. There is a problem adding monitoring – please try again later There is a problem adding the subscription – please try again later. Are you sure you want to unsubscribe? Kontakt venligst Dansk Standard. Continue shopping Proceed to checkout. The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The printed version is available at half price when you buy the electronic version.
ASTM D Standard
Do not show this again. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results. You must be logged in to sign up satm monitoring You must be logged in to sign up for subscription.
Permeation with other liquids, such as chemical wastes, can be accomplished using procedures similar to those astk in this test method. It was not possible to unsubscribe – please try again later or contact the Danish Standard Please make sure you are logged in.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applic.
This test method applies to porous materials containing little or no air. Experience has sometimes shown that adtm patterns in small, laboratory-prepared test specimens do not necessarily follow the same patterns on large field scales and that hydraulic conductivities measured on small test specimens are not necessarily the same as larger-scale values.
Historical Version s – view previous versions of standard. The hydraulic conductivity of compacted materials that have hydraulic conductivities greater than 1? Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors.
By tradition in U. The problem tends to be of minimal significance for materials that swell when exposed to water for example, compacted, clayey soils but can be a qstm serious problem for materials that might tend to shrink and pull away from the walls of the permeameter. However, this test method is only intended to be used when water is the permeant liquid.